VE Transfer Switch installation phase 2 complete and test. Solar power Infrastructure installation.Introduction of “Alexey Chekurkov’s “Graviflyer. The OAUGDP (One Atmosphere Uniform Glow Discharge Plasma). The GMR (Graphite Microwave Resonator), Part 2. I also think about a booster circuit to increase the voltage to the primary coil. Next, I will go up to 500 Watt but will demonstrate outside of my house. You find the video on any domain under research/courses/electronics-design/high-frequency-amplifier-for-scalar-wave-systems/. This video is only for Basic and Full members.

The voltage probe was too close that the wave curve could not be displayed correctly anymore above 5 KV with a 2 KV voltage prove in a distance of 40 cm. I exceed the benchmark of 200 Watt and after I produced the video, I could increase to 371 Watt without any problems.

The components I use cost only 20-30 Euros and deliver 500 Watt of power. In this video you will learn that simple works best.

Even with more power added, the wave on the Tesla coil did not increase. The classic Half Bridge design has flaws from an impedance and performance point of view which makes it difficult to scale up. It appears there is a very small parasitic capacitor on the output of the transformer to ground, that is not shown in most of the schematics for this circuit. While I was able to show successful half bridge configuration many years ago in England on YouTube, the performance could not be increased above a certain value. YAY, we approved the circuit and I was an skeptic for no reason (almost) Thanks to /u/dizekat, /u/alez, /u/hatsunearu and others, we figured out how this circuit oscillates. In this latest educational video, I like to demonstrate the performance of power mosfet in the pull – pull configuration.

Slayer exciter with mosfet without ic